FOG LIGHT INSTALLATION INSTRUCTIONS

All 1991-1993 AND MOST 1994 CAPRIS WERE PRE-WIRED FOR FOG LAMPS.

THE PLUG FOR THE DASH SWITCH IS ATTACHED TO THE BACK OF
THE DASH PANEL BLANK, NEXT TO THE A/C SWITCH. THE PLUG FOR THE RELAY IS IN THE
ENGINE COMPARTMENT, WITHIN THE WIPER MOTOR WIRING HARNESS.
ALL OF THE NECESSARY WIRING WAS INSTALLED IN YOUR CAPRI DURING FACTORY ASSEMBLY.

THE FOG LIGHT KIT CONSISTS OF:

(1) ORIGINAL FORD DASH SWITCH W/INDICATOR LIGHT.
(1) ORIGINAL FOG LAMP RELAY
(2) NEW NON-ORIGINAL, TESTED, FOG LAMP ASSEMBLIES WITH
CORRECT MATCHING ELECTRICAL PLUGS.
(2) NEW FOG LAMP HOUSING-TO-FRAME BRACKETS W/NUTS.

INSTALLATION INSTRUCTIONS:

1. DISCONNECT NEGATIVE BATTERY TERMINAL

2. PRY OFF DASH PANEL BLANK, TO THE LEFT OF HEADLIGHT
SWITCH.

3. SEPARATE WIRING PLUG FROM BLANK. PUSH WIRING PLUG INTO
BACK OF SUPPLIED DASH SWITCH. IF THE PLUG IS NOT
ATTACHED TO THE BLANK, IT MAY HAVE FALLEN OFF OR BEEN
DETACHED ACCIDENTALLY.

4. REMOVE EXISTING LH & RH AIR VENT COVERS FROM FRONT BUMPER AND
LOCATE FLAT DUAL-WIRE FOG LAMP ELECTRICAL PLUGS BEHIND
BUMPER ON FRAME.

5. INSTALL FOG LAMPS & BRACKETS USING NUTS PROVIDED.
WORK FROM UNDER BUMPER & INSERT FOG LAMP ASSEMBLY

6. CONNECT FOG LAMPS TO EXISTING PLUGS (SEE STEP 4)

7. MOUNT FOG LAMPS BRACKETS TO EXISTING FRAME STUDS USING
SUPPLIED 13MM SPINLOCK NUTS.

8. CHECK FOR 20 AMP FUSE IN FUSE BOX UNDER THE DASH ON DRIVER'S SIDE

9. INSTALL SUPPLIED RELAY (#14N089). LOCATE FACTORY
INSTALLED FOUR WIRE, FEMALE PLUG. IN WIRING LOOM HIGH
& TO LEFT OF MASTER CYLINDER, NEAR BACK OF THE BATTERY.

10. RECONNECT NEGATIVE BATTERY TERMINAL.

11 . CHECK OPERATION (NOTE: FOG LIGHTS ARE ONLY ON WHEN
HEADLIGHTS ARE ON, & OFF WHEN THE HIGH BEAMS ARE ON.
NB: AIM FOG LAMPS SO NOT TO BLIND ON-COMING DRIVERS.

Untitled

Roo-Sport
1-503-919-4227 OR 1-847-370-3760

Email: CapriTypeR@Gmail.com

"Helping You Care For
Your Capri!"